Datalogic DS4300 Manuel d'installation télécharger pdf (Page 36)

DATALOGIC DS4300

Installation -

2.21

2.6 TYPICAL LAYOUTS

The following typical layouts refer to system hardware configurations. Dotted

lines in the figures refer to optional hardware configurations within the

particular layout.

These layouts also require the correct setup of the software configuration

parameters. Complete software configuration procedures can be found in the

Guide To Rapid Configuration

in the WinHost Help On Line.

2.6.1 Point-to-Point

In this layout the data is transmitted to the Host on the main serial interface.

Host Mode programming can be accomplished either through the main

interface or the auxiliary interface.

In Local Echo communication mode, data is transmitted on the RS232

auxiliary interface independently from the main interface selection.

When On-Line Operating mode is used, the scanner is activated by an

External Trigger (photoelectric sensor) when the object enters its reading

zone.

DS4300

Terminal

Host

Auxiliary serial interface (Local Echo)

External Trigger (for On-Line mode)

Main serial interface

Figure 2.28 - Point-to-Point layout

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 52 53

Pas de commentaire

Datalogic DS4300 Manuel d'installation Page 36