Datalogic DS4300 Manuel d'installation télécharger pdf (Page 20)

DATALOGIC DS4300

Installation -

2.5

2.3.2 Junction Box Electrical Connections

The connection and wiring procedure for the junction box is described as

follows:

1) Open the junction box by unscrewing the 4 cover screws.

2) Pass all System cables through the glands in the junction box housing.

3) To connect the power and input/output signals:

•

Prepare the individual wires of the system cables by stripping the

insulation back approximately 11 mm.

•

Using a device such as a screwdriver, push down on the orange

lever directly above the clamp (see Figure 2.6).

•

Insert the wire into the clamp and release the lever.

The wire will now be held in the spring clamp.

Figure 2.6 - System cable connections to the junction box

The wiring used can be solid or stranded but must meet the following

specifications.

Positions 1-4: 24 - 16 AWG 0.2 - 1.5 mm²

Positions 5-39: 26 - 20 AWG 0.14 - 0.5 mm²

The junction box pinouts are indicated in the following table:

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 52 53

Pas de commentaire

Datalogic DS4300 Manuel d'installation Page 20