Datalogic Star Manuel d'installation télécharger pdf (Page 90)

STAR-LINK™

METHOD SETCONFIGURATION

PURPOSE

Sets the base station configuration.

DESCRIPTION

This method sets new configuration parameters. Be careful while setting the

parameters because a wrong configuration causes an incorrect operation of

the base station.

Since the SetConfiguration method updates all the base station parameters, it is

advised to follow the given procedure to change or update some of the base station

properties:

1. select the GetConfiguration method to get the current value of all the base

station properties;

2. change the desired properties only;

3. select the SetConfiguration method.

If the SetConfiguration command is not right, the control sends an error event

(ErrorEvent).

IDL

[id(23), helpstring("method SetConfiguration")] HRESULT SetConfiguration();

INPUT PARAMETERS

None

OUTPUT VALUE

None

POSSIBLE VALUES

None

EXAMPLE

...

Dim SatObject as Sat

...

‘ Setting new ID to the satellite

Set SatObject = RFNCCTL.Satellites.Satellite(1500)

SatObject.NewSatID = 1501

SatObject.SetConfiguration

...

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 127 128

Pas de commentaire

Datalogic Star Manuel d'installation Page 90