Datalogic Controller SC6000 Manuel d'installation télécharger pdf (Page 40)

BHS AND REDS INSTALLATION MANUAL

4.6 FINAL CHECKS

After sending the correct parameter configuration, the SC6000 will restart and the system is

ready to work.

Verify the following:

make sure that for each scanner an asterisk (“*”) is shown on the SC6000’s status

window

make sure that the speed shown by the SC6000 is consistent with the conveyor speed

run parcels with a known label so that it is read only by scanners on one side. Use the

“Last Code & Read Mask” window to check that the data output matches the expected

results

make sure that the Good Read rate (shown in the “Statistics Window”) is high

perform a system Backup so it will be possible to replace scanners or controller in case of

a failure, see par. 5.1 for details.

4.7 COMMISSIONING

During commissioning the whole system is tested to verify if it functions according to the

specifications. Please refer to the Commissioning Check List given in Appendix B.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 77 78

Pas de commentaire

Datalogic Controller SC6000 Manuel d'installation Page 40