Datalogic SC6000-1200 Manuel d'instructions télécharger pdf (Page 51)

SOFTWARE CONFIGURATION

2. If desired, select a slave scanner within the “Current Devices” area and click on the

icon (or select the “Show Device” option from the right-click menu) to make the

dialog box appear as follows:

The “Show Device” option is particularly useful after the Net-Autoset procedure or

whenever it is necessary to know which address is assigned to a specific slave

scanner. Indeed, it activates the following signals which physically indicate the

scanner corresponding to the one selected, in particular:

 in Network Wizard the icon corresponding to the selected slave scanner starts

blinking red;

 in the Physical Network all slave scanner lasers turn off except the one of the

selected scanner which turns on.

3. If desired, select the transferred/added slave scanner within the “Requested Devices”

area and click on the

icon to customize the scanner label and address.

4. Once your network has been customized, close the network wizard. Before closure,

the program will show a dialog box asking whether to send the new configuration to

the Master. Choose the “Yes” option to start this procedure.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 76 77

Pas de commentaire

Datalogic SC6000-1200 Manuel d'instructions Page 51