Datalogic SC6000-1200 Manuel d'instructions télécharger pdf (Page 43)

INSTALLATION

7. At the last step in the sequence the display prompts to place a barcode label

centered onto the physical X position (X Offset) on the conveyor and then press

Enter to Continue. You have 2 minutes to read the code before the procedure ends

automatically.

NOTE

Be careful that the barcode is not accidentally read in the act of placing it at

the desired X Offset position, and assure that it is read by only one

scanner (see the figure below). After placing the barcode label on the X

coordinate, you may have to pass your hand or other opaque object over it

to end this step.

Pressing Clear at any point will terminate the procedure without saving the Absolute X

position alignment.

NOTE

Before resetting the SC6000, if desired, you can download the Auto

PackTrack Report file from the SC6000 RAM by connecting it to Genius™

and using the Tools>File transfer… menu. See Help On-Line.

8. Manually reset the SC6000.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 76 77

Pas de commentaire

Datalogic SC6000-1200 Manuel d'instructions Page 43