Datalogic DS8100A-3115 Manuel d'installation télécharger pdf (Page 100)

DS8100A REFERENCE MANUAL

Calibration Type: XYZ calibration with Absolute X position is forced. The coordinates for the

three axes are calibrated. The X coordinate for all slaves is relative to a precise point

(reference point). This requires that the X Offset be set which will be used to harmonize the

X=0 coordinate of all of the individual slaves.

NOTE

For Oscillating Mirror models the scan line must be parallel to the conveyor

direction and only the Y calibration will be performed, (the X and Z axes will

automatically be set to zero).

Z Offset (if necessary): for packs that are elevated above the conveyor surface (for example

on tilt trays), this parameter sets an offset for the height of a pack so that Z = 0 corresponds

to the bottom of the pack.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 140 141

Pas de commentaire

Datalogic DS8100A-3115 Manuel d'installation Page 100