Datalogic Connection Box C-BOX 150 Manuel d'installation télécharger pdf (Page 48)

DS2100N REFERENCE MANUAL

ID-NET™ Network Termination

The network must be properly terminated by a 120 Ohm resistor in the C-BOX 100/150 of the

first and last scanner of the network.

3.3.4 Auxiliary RS232 Interface

The auxiliary serial interface is used exclusively for RS232 point-to-point connections.

The parameters relative to the aux interface (baud rate, data bits, etc.) as well as particular

communication modes such as LOCAL ECHO can be defined using the Genius™ utility

program or Genius™ based Host Mode Programming installed from the CD-ROM.

The following pins of the 25-pin connector are used to connect the RS232 auxiliary interface:

Pin Name Function

20 RXAUX Receive Data

21 TXAUX Transmit Data

7 SGND Signal Ground

SGND

TXD

RXAUX

RXD

TXAUX

USER INTERFACEDS2100N

Chassis

Figure 28 - RS232 Auxiliary Interface Connections

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 79 80

Pas de commentaire

Datalogic Connection Box C-BOX 150 Manuel d'installation Page 48