Datalogic QLM500 Manuel d'instructions télécharger pdf (Page 17)

RAPID CONFIGURATION

NOTE

If necessary you can use the Fine Focusing Tool in the VisiSet™ Setup

Wizard for fine focusing. See Step 8.

Figure 8 – Focus Function Using Blue Diamonds™

6. Exit the Focus function by pressing the X-PRESS™ push button once. The Blue

Diamonds™ turn off.

7. Replace the lens cover, screwing it tightly to the base.

STEP 5 – CALIBRATE IMAGE DENSITY

In order to function correctly to the fullest extent of its capabilities, Matrix 410™ must acquire

information regarding image density or PPI (pixels per inch). This calibration takes place

through the X-PRESS™ Interface and the Grade A Barcode Test Chart included in the

package. This procedure is necessary for the first time installation, if the lens type is changed

or if the focal distance is changed.

Locate

1. Enter the Focus function by pressing and holding the

X-PRESS™ push button until the Focus LED is on.

2. Release the button to enter the Focus function. The

Blue Diamonds™ turn on.

3. From the Grade A Barcode Test Chart, select the

longest code whose length fits between the two Blue

Diamonds™. Rotate the code 90 degrees and

position the code at the center of the FOV

(equidistant from the Blue Diamonds™).

4. Exit the Focus function by pressing the X-PRESS™

push button once. The Blue Diamonds™ turn off.

READY

green

yellow

red

SETUP

FOCUS

TEST

LEARN

GOOD

TRIGGER

COM

STATUS

Figure 9 – X-PRESS™ Interface:

Locate Function

Your reader can have one of the

above types of Blue Diamonds™.

Blue Diamond™

in focus

FOV

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 160 161

Commentaires sur ces manuels

Pas de commentaire

Datalogic QLM500 Manuel d'instructions Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de codes-barres Datalogic QLM500