Datalogic Rhino 10 Manuel d'utilisateur télécharger pdf (Page 30)

User Manual Rhino™ 10

Troubleshooting the Rhino

If you send the Rhino™ 10 in for service, it is your responsibility to save the computer data and configuration. Datalogic

is responsible only for ensuring that the hardware matches the original configuration when repairing or replacing the

computer.

Problems While Operating the Rhino™ 10

Problem Solution

You press Power and nothing hap-

pens.

• Make sure you are connected to a power supply (the green

LED should be on or blinking).

• Make sure the brightness is not set all the way to the darkest or

lightest setting. Press the UP key until you reach the desired

brightness level.

• Warm boot the Rhino 10 by pressing the reset button inside the

upper left cover.

• If the Rhino™ 10 will not reboot, contact Datalogic or your local

Datalogic service representative for help.

The Rhino™ 10 appears to be locked

up and you cannot enter data.

• Press and hold Power to turn off the Rhino™ 10 and then turn

it back on.

• Warm boot the Rhino 10 by pressing the reset button inside the

upper left cover.

• If the Rhino™ 10 will not reboot, contact Datalogic or your local

Datalogic service representative for help.

You tap the screen and nothing hap-

pens.

• Align your screen. For help, see Calibrate the Touch Screen on

page five.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Pas de commentaire

Datalogic Rhino 10 Manuel d'utilisateur Page 30