Datalogic QLM700 Manuel d'instructions télécharger pdf (Page 61)

CBX ELECTRICAL CONNECTIONS

NOTE: To avoid electromagnetic interference when the reader is connected

to a CBX connection box, verify the jumper positions in the CBX as indicated

in its Installation Manual.

4.1 POWER SUPPLY

Power requirements and conditions depend on the Matrix 300™ model: Standard or PoE

(Power over Ethernet).

4.1.1 Standard Models

For these models power can be supplied to the reader through the CBX100/500 spring clamp

terminal pins as shown in Figure 30:

Figure 30 - Power Supply Connections

The power must be between 10 and 30 Vdc only.

It is recommended to connect the device CHASSIS to earth ground (Earth) by setting the

appropriate jumper in the CBX connection box. See the CBX Installation Manual for details.

4.1.2 Power over Ethernet (PoE) Models

The Ethernet pinout is as follows:

Figure 31 - M12 D-Coded Female Ethernet Network Connector

Power over Ethernet Network Connector Pinout

Name

Function

TX +/DC-

Transmitted data (+) DC power (-)

RX +/DC+

Received data (+) DC power (+)

TX -/DC-

Transmitted data (-) DC power (-)

RX -/DC+

Received data (-) DC power (+)

V+

Earth

Ground

Power Supply

VGND

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 159 160

Pas de commentaire

Datalogic QLM700 Manuel d'instructions Page 61