Datalogic QLM700 Manuel d'instructions télécharger pdf (Page 22)

MATRIX 300™ REFERENCE MANUAL

The reader starts the focus procedure and gives

visual feedback in the Setup Wizard window. The

Setup Result section of the Setup Wizard window

reports the procedure progress (in percentage).

At the end of the procedure the Reading Distance,

PPI and FOV data are reported.

6. Now place a single application specific code in front of the reader (at the same reading

distance) and repeat steps 3, and 4. Do not perform step 5 "Fine Focusing".

7. Select a Code Setting Mode choice and press the "Code Setting" button.

The Setup Result section of the Setup Wizard window shows the code type results.

NOTE: The Grade A Barcode Test Chart cannot be used to set the Code

128 symbology (even though the reader successfully reads the code). Use

the application specific code if you need to set this symbology.

Setup Result

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 159 160

Pas de commentaire

Datalogic QLM700 Manuel d'instructions Page 22