Datalogic PowerScan PM8300 Spécifications télécharger pdf (Page 2)

820045314 (Rev B) - December / 2011 Page 2 of 2

Operation

1. If the Heated Holder is connected to the ignition switch, turning the ignition switch on or off will control the heated holder. An LED illumi-

nated from the inside of the holder indicates the power is on.

2. Place the scanner into the holder (see Figure 2). Push the scanner through the front brushes as far as it will go. The brushes should return to

their original position.

Figure 2. Inserting the scanner in the Heated Holder

Specifications

Physical

• Dimensions: 7.7 in. (19.6 cm) L

• 4.8 in. (12.2 cm) W

• 3.9 in. (9.9 cm) H

Environmental

Temperature

• Internal operating: Operating Solid State Control at 95º-

105ºF (35º-40ºC)

• Ambient operating: 22º to 104ºF (-30º to 40ºC)

• Storage: -40º to 158ºF (-40º to 70ºC)

Humidity (Ambient): 5% to 95% (non-conducting)

Vibration: MIL-STD-810E. Method 514.4, Procedure 1

Approvals

CE, TUV

Electrical

Power Cable:

• 10 ft. (3.05 m) L (unterminated)

• 18/2 Conductor cable

• Red wire: + positive lead

• Black wire: - negative lead

Patents: This product is covered by the following patent.5,508,505.

WARNING

Do not put your fingers or hands inside the unit while it is on. Surfaces inside the unit are hot and may cause burns. Do

not use the Heated Holder as a handle; it is not intended to support human weight.

Heated

Holder

Scanner

Front

Brushes

Model Input Input Power

Number Voltage Current Output

721091900 24 VDC 2.7 A 70 W

721092000 36 VDC 2.2 A 70 W

721092100 48 VDC 1.6 A 70 W

1 2

Pas de commentaire

Datalogic PowerScan PM8300 Spécifications Page 2