Datalogic POWERSCAN PBT7100 guide Manuel d'instructions télécharger pdf (Page 13)

Linking the Scanner to a Base Station

Product Reference Guide 1-5

Linking the Scanner to a Base Station —

cont.

When the generic Link to Base Station label (shown below) is used for

linking, you will notice that linking is slower and a rescan of the label

may be required before a successful link is made. If two Base Stations are

in the linking mode at the same time, the generic label will not be able to

initiate a successful link, since the scanner will not know which Base Sta-

tion it is supposed to link to.

A successful link is indicated by three ascending tones from the scanner.

A high-low-high-low tone indicates the link attempt was unsuccessful. A

single green LED flash during this tone indicates no Base Station was

discovered. Two green LED flashes during this tone indicates that more

than one Base Station was discovered and the scanner did not link.

Figure 1-3. Labeling and Nomenclature

Link to Base Station

This illustration shows label placement ONLY.

For actual regulatory, patent and other applicable

information, view the labels on the product intself,

or call your nearest sales or service office.

Scan

Window

Trigger

Indicator

LEDs

S/N and Laser Safety Label

Speaker

Port

Battery Pack

Battery Latch

Antenna

Link Bar Code

Scanner

Latch

Link

Button

Green LED

Amber

LED

Scanner

Base Station

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 271 272

Pas de commentaire

Datalogic POWERSCAN PBT7100 guide Manuel d'instructions Page 13