Datalogic QLM500 Manuel d'installation télécharger pdf (Page 6)

SAFETY AND COMPLIANCE NOTICES

CAUTION

Subzero model scanners must not be opened in an uncontrolled

environment.

LASER SAFETY

The following information is provided to comply with the rules imposed by international

authorities and refers to the correct use of the DS2400N scanner.

Standard Regulations

This scanner utilizes a low-power laser diode. Although staring directly at the laser beam

momentarily causes no known biological damage, avoid staring at the beam as one would

with any very strong light source, such as the sun. Avoid that the laser beam hits the eye of

an observer, even through reflective surfaces such as mirrors, etc.

This product conforms to the applicable requirements of IEC 60825-1 and complies with 21

CFR 1040.10 except for deviations pursuant to Laser Notice N° 50, date June 24, 2007. The

scanner is classified as a Class 2 laser product according to IEC 60825-1 regulations.

There is a safety device, which allows the laser to be switched on only if the motor is rotating

above the threshold for its correct scanning speed.

The laser beam can be switched off through a software command (see also the Genius™

Help On Line).

WARNING

Use of controls or adjustments or performance of procedures other than

those specified herein may result in exposure to hazardous visible laser

light.

The laser light is visible to the human eye and is emitted from the window on the front of the

scanner (Figure A, 7).

Warning labels indicating exposure to laser light and the device classification are applied

onto the body of the scanner (Figure A, 1).

Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: [email protected]

1 2 3 4 5 6 7 8 9 10 11 ... 118 119

Pas de commentaire

Datalogic QLM500 Manuel d'installation Page 6