Datalogic Matrix 400 Manuel d'instructions télécharger pdf (Page 95)

TYPICAL LAYOUTS

In this layout a single reader functions as a Slave node on a Fieldbus network. The data is

transmitted to the Host through an accessory Fieldbus interface board installed inside the

CBX500 connection box.

Reader configuration can be accomplished through the Auxiliary interface using the VisiSet™

configuration program or Host Mode programming.

In Local Echo communication mode, data is transmitted on the RS232 auxiliary interface

independently from the Fieldbus interface selection.

When One Shot or Phase Mode operating mode is used, the reader can be activated by an

External Trigger (photoelectric sensor) when the object enters its reading zone.

Figure 102 – Fieldbus Interface Point-to-Point Layout

Matrix 400™

 Fieldbus Interface (Profibus, DeviceNet, etc.)

 Auxiliary Serial Interface (Local Echo) (RS232)

 External Trigger (for One Shot or Phase Mode)

Host

Power

CBX500

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 146 147

Pas de commentaire

Datalogic Matrix 400 Manuel d'instructions Page 95