Datalogic DS4300 Manuel d'installation télécharger pdf (Page 14)

OM4000

2.5 ADJUSTMENT

The OM4000 can be configured to operate in different modes by setting hardware

switches located inside the oscillating mirror body. See the figure below. To access

these switches you must remove the four cover screws shown in the figure below.

Figure 9 - Opening the OM4000 body for configuration

The following operating modes can be configured:

•

Oscillating - mirror always oscillating (see par. 2.5.1).

•

Triggered - mirror stopped after reading phase off (see par. 2.5.2).

•

Fixed - mirror set to fixed angle (see par. 2.5.3).

The following table describes the allowable switch settings for OM4000 configuration.

Operating Modes

Switches Oscillating Triggered Fixed

Mode 1 0 indifferent

Min Position 1-D 1-D 0

Max Position 3-F 3-F 1-F

Frequency 1-F 1-F indifferent

Table 1 - Allowable switch settings

Combinations other than those specified in the table are erroneous and will cause the

red ERROR LED to turn on.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 22 23

Pas de commentaire

Datalogic DS4300 Manuel d'installation Page 14